Environmental Performance Score
—/100
No inputs yet
Dashboard & Environmental Aspects
This page is linked to all category calculators. Add readings in Air & Fumes, Water / pH, Materials, or Waste tabs to activate the measured dashboard and aspects register.
No data
Reference-based Status
—%Pollution Load vs Entered Limit
—%Contamination Severity Index
—/5Critical Alerts
0Open Recommendations
0Air Emissions & Fumes
% of entered limitNo air inputs yet.
Water Quality / pH
range and limit basedNo water inputs yet.
Material Hazard & Viscosity
SDS / GHS inputsNo material inputs yet.
Waste & Contamination
generated from waste inputsEnvironmental Aspects & Impacts Register
ISO 14001-aligned register generated automatically from category inputs. Rows appear only when inputs exist.
| Aspect ID | Category | Activity / Source | Environmental Aspect | Environmental Impact | Risk Score | Significance | Recommendations |
|---|
Top Significant Aspects
No significant aspects yet.
Environmental Risk Heat Map
Severity × LikelihoodRecommendations Tracker
Measured Performance Trend
from saved entriesAir Emissions & Fumes
Add actual measurements or calculated values. The dashboard updates immediately after saving the entry.
Saved Air & Fume Inputs
Water Quality / pH
Enter pH and wastewater parameters. pH is evaluated as a range; other parameters use actual value vs entered limit.
Saved Water / pH Inputs
Material Hazard & Viscosity
Add material condition data from SDS or site storage observations. Hazard score feeds the dashboard and aspects register.
Saved Material Inputs
Waste & Contamination
Add waste generation, hazardous waste ratio, spill quantity, and contamination observations.
Saved Waste & Contamination Inputs
Reference Library
Reference mapping used by the calculator. Numerical limits must be entered from the applicable permit, legal requirement, SDS, occupational limit, internal standard, or custom reference.
Saudi Environmental Law / NCEC / Permit References
Use this group when the entered value comes from an environmental permit, Saudi environmental law/regulation, inspection condition, or project-specific compliance obligation. The calculator does not assume compliance unless the user enters the applicable limit.
ISO 14001 EMS Mapping
Used for environmental aspects, impacts, compliance obligations, operational controls, monitoring, documented records, and continual improvement mapping. ISO 14001 is not used as a pollutant numerical limit.
- Clause 6.1.2: environmental aspects and impacts mapping
- Clause 6.1.3: compliance obligations mapping
- Clause 8.1: operational planning and control mapping
- Clause 9.1: monitoring, measurement, analysis, and evaluation mapping
Air Emissions / GHG Calculation References
Use this group for calculated emissions when direct monitoring is not available. Values should still be compared against the applicable permit or entered limit.
SDS / GHS Chemical References
Use this group for hazard class, flash point, vapor pressure, pH, compatibility, storage controls, spill response, and PPE/control recommendations.
Occupational Exposure References
Use this group when fumes, vapors, gases, or dust exposures are compared with workplace exposure benchmarks such as TWA, STEL, or ceiling values.
Internal / Custom Limits
Use this group for company-defined warning thresholds, preventive limits, action levels, storage duration criteria, and monitoring criteria. The report labels these as internal/custom unless independently verified.
- Enter the actual numerical limit inside the relevant category tab.
- Keep a copy of the approved internal standard or permit condition as evidence.
- When no reference is entered, the dashboard shows reference missing instead of compliant.